69
KARMA Medical Taiwan would always recommend transferring to a car
seat within a vehicle; however, should this not be possible, the following
is the safest method:
a.
The wheelchair must be positioned in a forward-facing position.
b.
An Unwin restraint system like model Gemini 3 or a different brand with
equivalent specification must be used.
c.
As a car safety belt a Klippan Safety AB belt, model 907428 or a
different brand with equivalent specification must be used.
d.
The restraint system must be fixed on the specific points of the
wheelchair, which show a label of a transportation hook.
e.
A head restraint system must be fitted during transportation. This device
must be suitably positioned and able to stay on during transportation.
f.
The center point of gravity of the wheelchair during transportation should
be as low as possible. A powered seat elevator must be in its drive position,
the backrest should be upright, the seat should be in a horizontal position
and the legrest should be positioned in a normal seating positions.
g.
During transportation the wheelchair should be switched off to prevent it
from moving by accidental joystick use.
h.
Make sure the tire pressure of each wheel of the wheelchair is in the
optimal condition. Too low tire pressure can result in an instable behavior
of the wheelchair during transportation.
Any wheelchair anchored occupant restraint i.e. 3-point belt, harness or
postural supports (lap straps, lap belts) should not be used or relied on for
occupant restraint in a moving vehicle, regardless if labeled ISO 7176-19,
ISO 10542-1, SAE J2249 or any other. Use a vehicle anchored and certified
occupant restraint system instead.
When shipped by boat, please give special attention to prevent contact with
salt water or air. Salt water is extremely corrosive and might lead to
unwanted damage of the product.
To Next Page
Loading...
Need help?
General
