70
19.1.1
Transportation guideline
The wheelchair has a 4-point heavy duty webbing restraint.
Using two brackets on the front end and two brackets on each
rear side of the chassis. The brackets are indicated with a sticker.
These securing points and its location have been designed
according to ISO7176-19:2008
The angle of the straps should be around 45° to the horizontal plane. This is to have
maximum effect in vertical and horizontal direction.
The straps must be connected to the vehicle at suitable anchor points. Make
sure that the tire pressure is at the recommended level, so straps can have
maximum effect. Make sure straps are tightened to keep optimal security.
Poor fixations of the wheelchair in a vehicle might cause damage to the
vehicle itself, the wheelchair or the passengers inside the vehicle while
driving. Not using a car safety belt while sitting in a wheelchair might lead
to serious injuries in case of an accident.
Please note that the transport loops are optional. If the wheelchair is
not equipped with transport loops, it is prohibited to be transported on
the vehicle.
Alterations or substitutions should not be made to the wheelchair
securement points or to structural- and frame parts or components without
To Next Page
Loading...
