38
until it clicks into place.
7.12 Installing a Pelvic Belt (See Figure 7.6)
7.12.1 After market pelvic belts are a great idea for all users of powered scooters.
Scooters are motorized vehicles. Some local or regional laws may require
drivers to wear pelvic belts. Contact your local government center for more
information to insure you use your scooter within the laws of your region.
7.12.2 Figure 7.3 shows the location where a pelvic belt can be attached by your
Karma service provider. They have all the tools, service manuals and technical
know-how to assure your safety through a proper installation. Karma does
NOT recommend installation of a pelvic belt by anyone other than an
authorized Karma service provider
Figure 7.6
7.13 Removing/Installing The Rear Casing
7.13.1 Removing
To install the rear casing, reverse the following procedure.
7.13.1.1 Remove the seat.
7.13.1.2 Slowly remove the rear casing and place it on the floor close to the
scooter. Disconnect the taillight wiring connector from the battery wiring
connector. Arrange wires neatly with the rear casing.
CAUTION
● CAREFULLY remove the rear casing because the wiring connector for the
taillights is connected to the batteries connectors. Otherwise, damage
may occur.