www.kart.pl
13
Position 135 - 280
or
Position 280 - 360
10. Depending on the degree of wheel contamination, press the suitable washing time pushbutton. The washer is
has three washing times pre-programmed in the factory, i.e.: 1 (20 seconds), 2 (40 seconds), and 3 (60
seconds), and the 15-second drying time. Years of experience gained by users show that such settings are
optimum and most energy saving, while ensuring the highest efficiency. If wheels are extremely dirty and
washing result is still unsatisfactory, the washing cycle can be repeated. To reduce washing time below 20, 40,
and 60 seconds respectively, press the STOP button and then the V button. Due to electronic type of control, it
is also possible to set any washing and drying time, thus adopting the washer settings to individual needs of a
particular user.
11. Upon completion of the washing cycle, the drying cycle starts automatically and lasts for 15 seconds. Each of
the washing and drying processes can be interrupted at any time by pressing the STOP pushbutton. During the
drying cycle the granulate residuals are removed by compressed air.
12. When the wheel is already washed and dried, open the washing chamber flap and remove the clean wheel from
the inside. Before fixing the wheel to the car remove residuals of granulate possibly left on the wheel after the
drying process.
13. At the end of working shift, disconnect both the electric power and compressed air supply to the washer.
NOTE: DO NOT OPEN THE WASHING CHAMBER DURING WASHER OPERATION!
The washing chamber flap position sensor installed in the washer prevents starting the washer if the flap is fully or
partially open. The open flap is signalled on the display by the CLOSE message. Upon closing the flap, the CLOSE
message disappears from the display and the washing processes can be started again.
CLEANING THE WASHER
To ensure full availability of the washer and to extend its lifetime, it is necessary to keep it clean according to
specifications.
Planned dates of washer’s cleaning must be strictly observed. During the winter season, when roads are sprinkled with
chemical anti-freezing substances, pay particular attention to the foam and remove it at once, if appears, since this foam
lowers the quality of washing by creating the wrong level of washing medium and possibly by causing the granulate to
clog the sprinkling nozzles.
When any washing cycle is started, this event is recorded by in-built counter programmed for 500 washing processes.
When the counter reaches this number of counts, the washer is automatically blocked and requires cleaning from dirt
and replacing water. The drying process is counted as a final stage of washing cycle. Starting the additional drying cycle
is not recorded by the counter as a separate washing cycle. To achieve one-to-one correspondence between counter
counts and the number of washed wheels, it is necessary to set washing times according to actual needs so that one
washing cycle is performed for every single wheel. Repeating the washing cycle for the same wheel will be recorded as
next, separate cycle. The service lock can be reset by simultaneous pressing and holding for ca. 10 sec. of RESET
ENTER PROG pushbuttons, in this particular order, with the machine switched on.
To Next Page
Loading...