www.kart.pl
16
REPAIRS
The person who operates the washer should immediately report all malfunctions, defects and damages that are found
during machine operation. The washer can be repaired only by manufacturer’s personnel or by the authorised person
trained by the manufacturer. Moreover, the person who repairs the washer must have all required qualifications and
skills. In case of worn or damaged parts which are not classified as separate replacement parts and constitute an
integral part of the unit in which they are working (e.g. driving shaft, supporting shaft and so on), the manufacturer will
perform renovation of such part or will deliver a brand new unit.
The table below shows the possible causes of defects and malfunctions, along with repair recommendations.
Noisy operation of
washer.
Overload protection of
main motor triggers
repeatedly.
Insufficient level of washing
medium or too much
granulate in water.
Increase the amount of washing medium to the
indicated level, remove some amount of
granulate from washer.
Noisy operation of the
contactor, possible
sparking.
“Striking” the wheel with
granulate is not heard.
The wheel does not
rotate, falls or blocks
itself.
Worn spikes of the driving
shaft.
Even after the longest
washing cycle, the wheel
is not washed properly.
Insufficient amount of
granulate and washing
concentrate; water
contaminated.
Add granulate and/or washing concentrate;
replace water with fresh one.
Improper settings of cycle
times.
Reset the machine to factory settings.
Clogged nozzles or damaged
shaft.
Clean nozzles and turn the motor switch FT1 or
FT2 on; replace shaft.
“Strange” marks or
symbols appear on the
display.
The battery is faulty or
exhausted.
Replace the battery (type CR2032).
The washer does not start
- the message appears:
BLOCKADE
The service locks actuated
after performing 500 washing
cycles.
Reset the service lock by simultaneous pressing
and holding of RESET ENTER PROG
pushbuttons, then perform washer cleaning and
washing (recommended).
To Next Page
Loading...