Kato IC120-2 - User Manual

Questions and Answers

D
Denise MillsAug 12, 2025
Why is my Kato Construction Equipment machine not traveling fast and powerfully?
- J
  johnrodriguezAug 12, 2025
  Your Kato construction equipment may not travel fast and powerfully due to several reasons. It could be because the hydraulic oil is low, requiring you to supply oil up to the specified level. Alternatively, the relief valve pressure might be set too low, or there could be a defect in the motor, reduction gear, or pump, all of which may require repair or replacement of parts. Finally, an over-tensed crawler can cause this issue, and you should adjust both the right and left tension to the regular value.
S
Sheila LynchAug 20, 2025
What to do if my Kato IC120-2 machine does not travel smoothly?
- E
  elizabethdixonAug 20, 2025
  If your Kato construction equipment isn't traveling smoothly, here are a few things to check: * First, look for any stones or obstacles tangled in the tracks and remove them. * Second, ensure the crawler tension isn't too tight by adjusting the tension of both the right and left sides to the regular value. * Third, verify that the hydraulic oil is at the specified level and supply oil if it's low. * Finally, Inspect the motor, reduction gear, and pump for any defects, which may require repair or replacement.
T
Tony SchneiderAug 27, 2025
Why does my Kato IC120-2 Construction Equipment curve during travel?
- C
  carly75Aug 27, 2025
  If your Kato construction equipment curves during travel, it could be due to a few reasons. First, check for any tangled obstacles and remove them. Second, ensure that the tension on the right and left sides is equal by adjusting it to the regular value. Finally, inspect the stopper bolt of the travel selector lever to make sure it is not loose; if it is, adjust and fix it.
M
Mary TranSep 3, 2025
How to fix speed selection issues on Kato IC120-2 when changing selectors doesn't work?
- K
  Kathy SummersSep 3, 2025
  If the speed on your Kato construction equipment doesn't change when using the selectors, it may be due to a discontinuity or disconnection of the electric wires, or a defect of the solenoid valve for speed selection. In both cases, you should repair or replace the affected parts.