- 174 -
17-4 On-site moving
(
541A-0202-0E
)
Always observe the following points when moving within a site to change working positions.
Driving on public roads is not permitted when the machine is configured for on-site moving.
Return the machine to the on-road moving configuration before driving on public roads.
(
541A-0203-1E
)
(
1
)
Crane status: Driving mode
(
boom fully retracted, lowered and facing within ±1° of the front, and outriggers
stowed
)
(
2
)
Suspension: Suspension cylinders fully retracted and secured in locked position
(
3
)
PTO switch: ON position
(
4
)
Slewing table : Slewing brake engaged and slewing lock in use
(
5
)
Driving peed: Low speed
・ Moving within a site to change working positions is within the scope of crane operations.
Therefore, even if it involves driving, leave the suspension locked and the PTO switch "ON"
as well.
・ If the machine is moved with the suspension unlocked
(
on-road driving
)
or the PTO switch
"OFF", the operator may forget to fully retract the suspension at the next working position.
Therefore, be sure to lock the suspension in the fully retracted position before starting work at
the next position.
(
541A-0204-1E
)
To Next Page
