Tire Changer KT-830 User’s Manual
19
◇ Use the Wheel Clamp Foot Pedal to move the Clamps inward (pedal down) or outward
(pedal up).
4.2.3 Tire mounting
◇ Apply tire manufacturer’s approved rubber lubricant liberally to entire circumference of
both upper and lower beads after loosening bead and placing on table top.
◇ After the wheel is secured to the Turntable, swing the Vertical Arm into position. Use
the large adjusting Knob to position the Mount/Demount Head directly over the edge of
the rim.
◇ Push the Vertical Shaft down and position the Mount/ Demount Head into contact with
the rim edge.
To Next Page
Loading...
