W H E E L B L A N C E R
- 23 -
Display an error of a few
hundred grams
1. Memory value three
parameters messed up
2. The tire error is too big
1. Correct to standard value
according to instruction
2. Change a tire and try it
5.7 Self-check procedure (detect position sensor and indicator light)
Press < D > key, all indicator lights and digital tubes on the system panel are on
(if there is an electromagnet, the electromagnet will close; if there is a laser
indicating device, the laser will be lit) to check whether the display
(electromagnet and laser indicating) is normal.
5.7.1 Press < ALU >, and the display screen displays [POS] [XX]. At this time,
it can detect whether the position sensor is normal, and slowly rotate the tire
(XX) value by hand.
Note: In this state, when turning to [POS] [18], press key, and the display screen
displays [CAL] [-o -], indicating that the balance shaft base and zero clearance
can be carried out at this time. Under the condition that the balance shaft is not
loaded with tires, press the key to START the balancing machine for balance
calculation, until the display [CAL] [END] indicates that zero clearance is
completed. However, this kind of zero clearance because of the interference of
the belt and the box can not guarantee the absolute zero clearance shaft, but it
can be guaranteed within 4 grams.
5.7.2 Press < ALU > button to display [P0.] [XX]. At this time, the quality of
To Next Page
Loading...
