Kawasaki Teryx4 2014 +

To Next Page

Page 1 of 3

Assembly Instructions

Description

Plastic Hard Top

Model

Teryx4 2014 +

Part-Number

99994-0558

Approximate

Assembly Time

60 min.

Before you begin installation, read through the installation instructions and check to be sure all parts are

present.

If you are in doubt as to any part of the installation, please ask your authorized Kawasaki dealer to complete the

installation. Please note that Kawasaki cannot assume any responsibility for damage resulting from incorrect

installation.

Parts List

Ref. # Part Number Qty Description

A01 14092-1065 1 COVER

A02 11056-1405 2 BRACKET

A03 11056-1523 2 BRACKET

A04 11056-2483 1 LH BRACKET

A05 11056-2484 1 RH BRACKET

A06 92015-1339 8 NUT

A07 92152-1569 6 COLLAR

A08 92161-0644 2 DAMPER

A09 92161-1405 2 DAMPER

A10 92161-1476 2 DAMPER

A11 92161-1477 6 DAMPER

A12 92172-0002 8 SCREW

A13 92173-0884 2 CLAMP

A14 92161-1603 2 DAMPER

Installation Instructions:

1. Park the vehicle on level ground, set the parking brake, turn off the ignition switch.

2. Apply rubber dampers (A08) to the half circle-shaped end of the left and right rear brackets (A04, A05) as shown in Fig.

3. Apply rubber dampers (A09) to the underside of the roof in the two forward locations, each damper centered between

the two mounting holes as shown in Fig. 2.

4. Apply two rubber dampers (A14) to the middle ROPS cross member as shown in Fig. 3.

5. Appl

y six dampers (A11) to the bottom side of each of the six collars (A07) as shown in Fig. 4.

6. Apply two dampers (A10) to each of the two brackets (A03) as shown in Fig. 5.

7. Place the roof (A01) over the ROPS frame. Install two screws (A12) with two collars (A07) through the roof and

mounting hole of the ROPS forward cross member at the forward outer mounting points. Secure with two nuts (A06) on

the bottom side as shown in Fig. 5.

Need help?

Do you have a question about the Kawasaki Teryx4 2014 + and is the answer not in the manual?

Summary

Kawasaki Assembly Instructions Overview

Product Identification

Details the product model, part number, and estimated assembly time for the Teryx4 2014+ Plastic Hard Top.

Pre-Installation Guidance

Advises users to read instructions, check parts, and contact a dealer for assistance to ensure correct installation.

Installation Steps

Initial Preparation and Damper Application

Instructions for initial vehicle setup and applying rubber dampers to various brackets and roof components.

Bracket and Roof Attachment

Details on installing front and rear brackets, securing the roof using screws, collars, and nuts as per diagrams.

Final Tightening and Maintenance

Instructions for final hardware tightening and a recommendation for regular checks and adjustments of screws.