kb!ce KBFM1JA01 - First Time Use; Filling Water Reservoir; Flushing the Unit

1. Filling the water reservoir for the rst time use
• Remove the reservoir cover by simultaneously
pulling from the left and right side towards you
(See illustration 1).
• Add water to MAX WATER FILL and then
replace cover.
2. Flushing the unit for the rst time
• Plug the unit into power.
• Press and hold Clean button for 3 seconds to
start the Cleaning mode
• Unplug the unit when the ushing process is
complete (it takes 30 minutes and the Cleaning
LED goes off).
• Pull the drain tubes with plugs/holders out of
the unit back and remove the plugs/holders to
release water.
• Replace the plugs/holders and put the tubes
with plugs/holders back to the unit.
8
FIRST TIME USE
For the rst time use ush the unit following
instructions below.
For the rst time use dispense several cups of
ice and then discard them.
Water
Port
L
R
MAX Water Fill
Magnets
MIN Water Fill
Reservoir
Cover
Pug/Holders
Drain Tubes
1. 2.