KDK 24CURB - Page 15

15
Please wear the gloves when cleaning
the product.
清洁时请带上手套。
Awas
注意
Caution
MAINTENANCE
日常使用及维修
Otherwise, it may cause damage.
否则可能会导致受伤。
This product is applicable to living rooms,
washrooms and other places where the
humidity is not too high.
Otherwise, it may lead to short circuit
or electric shock.
否则可能会引起短路或触电。
本产品须安装在起居室、卫生间等湿度
不太高的场所。
Never immerse blade or other resin parts in hot water over 60 °C.
请勿把塑料部品浸入高于60 ℃的水中。
Never use petrol, benzene thinner or any other such chemicals for cleaning the product.
请勿使用汽油、苯、稀释剂或其他诸如此类的化学品擦拭换气扇。
Cleaning Precautions
清洁提示事项
Warning
警告
Louver
面罩
Gloves
手套
1 Remove the louver. (Fig.15)
拆下面罩(图15)。
MAINTENANCE
日常使用及维修
Clean product
清洁产品
2 Remove the motion sensor. (Fig.16)
去掉动作传感器(图16)。
Groove
沟槽
Fixed spring
固定弹簧
Gloves
手套
Vacum cleaner
吸尘器
Fig.15 / 图15
Fig.16 / 图16
Fig.17 / 图17
Fig.18 / 图18
Fig.19 / 图19
3 Clean Louver. (Don’t put into hot water.
Use non-abrasive kitchen detergent, wipe dry with
clean cloth) (Fig.17)
The Louver should be dry after cleaning.
用水冲洗面罩，干净的面罩请用柔软的干布擦干或
风干(图17)。
4 Clean the dirt of blades with vacuum cleaner.
(Fig.18)
使用吸尘器清除扇叶上的污物(图18)。
5 Wipe the dust off the fan body with a soft cloth
moistened with kitchen detergent, and then clear
it with a clean soft cloth. (Fig.19)
6 Finally, install the louver again. →refer to page 10
最后，重新装上面罩。→参考第10页
使用软布沾上厨房用洗涤剂后擦掉扇叶上的污物，
再用干净软布擦净(图19)。
Gloves
手套
Louver
面罩
Motion sensor
动作传感器
Louver
面罩
1
2