P30 Frequently asked questions (FAQ)
FAQ V1.01
11
© KEBA
Illustration2-2: Opening the power supply terminal
Are there options for controlling the charging current?
● Enable input [X1] to activate or deactivate the charging process
● Smarthome Interface (UDP), e.g. Loxone, Cohere, Smartfox
● Local charging management with P30 x-series
● For connection to an OCPP backend: Specification by the OCPP back-
end
What must be observed for installation in a (underground) garage?
● Official requirements
● Fire service regulations (ventilation systems, emergency shut-off de-
vices)
● When using GSM, check the signal strength in advance
● When laying power supply cables and network cables, steel conduit
pipes should be used for surface installation (sabotage-proof)
Are there any additional installation options?
Yes, on a column base. The information in the corresponding installation in-
structions must be observed.
When is the system ready for operation?
The charging station is ready for use if at least the left 3 segments of the
LED bar are flashing.
To Next Page
Loading...
