2. Laser mark
●Take measurement and determine where the laser line needs to be projected.
●Measure for position of laser line. (See “How to fix the tool”)
●Determine laser orientation.( Do not stare into the laser beam. See "Safety Instructions”)
a. Horizontal line: turn the tool (left or right) until the bubble above the tool is between the
two lines.
b. It can project laser line at an angle by rotating the tool and using hanging hole assistant
location instrument.
●Length of light adjustment: When projecting laser line, you can open the support board on the
back of the tool or place some object to underlay the whole tool to obtain suitable length of
the laser line.
Tips:
●The tool is designed to project a baseline on the surface of the object. The reflection of the
baseline on any other surfaces cannot be used as a reference.
● If the laser line is not visible during operation, please check and replace the battery.
●
The tool is recommended for indoor use. The visibility of the laser will be affected if the tool is
used outdoor.
Cautions
● Operate with care and do not let the tool drop down.
● Do not disassemble the tool in case of damage.
● Keep the tool dry and clean.
● Please place the tool with workbox when not use.
● Avoid dust and water, which may stain the lens.
● Avoid rain and water.
● Do not exposed the the tool to vibration and high or low
temperature environment.
● In case of damage of tool by deterioration of battery.
●
Remove the battery when not in use for an extended period of time
TECHNICAL SPECIFICATIONS
Name 5 in 1 Multifunction Gauge
Type KC-109A
Recommended use Indoor or indirect sunlight
Length of laser line 2m
Width of laser <5mm
Power of laser <1mW
Wavelength 630～660nm
Laser class Class Ⅱ
14
To Next Page
Loading...