7. After I successfully configured the IPC1000W to match my wireless network settings, I
cannot connect to the camera.
1. Verify that the wireless settings match your wireless network settings.
2. Make sure to disconnect the Ethernet cable from the camera and verify that the LINK LED is
blinking red.
8. I forgot my password. What should I do
Take a pin or paperclip and press the reset button on the back of the unit for 15 seconds. This will
return settings back to factory defaults. The default administrator ID and password is admin. Go
through the Hardware Installation and Configuration or Wi-Fi Protected Setup (WPS) Push Button Setup
section to reinstall the IP Camera.
If you still encounter problems or have any questions regarding the IPC1000W, please contact KEEBOX's
Technical Support Department.
Quick Installation Guide - KEEBOX IPC1000W
17
To Next Page
Loading...
Need help?
General