To Next PageTo Next Page
Need help?Do you have a question about the Keen Pump K(H)GS2 and is the answer not in the manual?
General| Model | K(H)GS2 |
|---|---|
| Category | Water Pump |
| Power Source | Electric |
| Frequency | 50 Hz |
| Material | Cast Iron |
Lists models with standard flow and radial cutters, detailing specifications.
Lists models with high head and radial cutters, detailing specifications.
Lists models with internal capacitors for radial cutter pumps.
Lists models with standard flow and axial slicers, detailing specifications.
Lists models with high head and axial slicers, detailing specifications.
Wiring diagram for single-phase pumps with internal capacitors and 10/3 cable.
Wiring diagram for single-phase pumps with 10/5 cable.
Wiring diagram for three-phase pumps with 14/7 cable.
Describes intended use and limitations for 2 HP grinder pumps.
Details pump packaging and available cord lengths.
Instructions for checking pump for shipping damage and impeller freedom.
Covers motor overload protection and moisture detection systems.
Specifies cord types and wire color coding for pumps.
States the required counter-clockwise rotation for the impeller.
Lists probable causes for a pump failing to start or run.
Lists causes for a pump running without pumping liquid.
Lists causes for a pump humming but not operating.
Lists causes for reduced water output from the pump.
Lists causes for unusual noise during pump operation.
Lists causes for the pump cycling on and off too often.
Lists causes for the pump failing to stop operation.
Lists causes for debris accumulation and pumping issues.
Explains the meaning of a red light indicating a pump issue.
Lists causes for the circuit breaker tripping.
Lists necessary tools for impeller and shredding ring replacement.
Safety warning about disconnecting power before disassembly.
Recommendations for sanitizing and cleaning the pump before work.
Step-by-step guide for disassembling the grinder impeller and shredding ring.
Lists tools needed for replacing axial slicer impeller and retainer plate.
Safety warning to disconnect power before disassembly.
Recommendations for pump sanitization and cleaning before disassembly.
Detailed steps for disassembling and replacing slicer plate and impeller.
Step-by-step guide for replacing the start kit on "C" model pumps.
Lists part numbers for various components of axial slicer models.
Lists part numbers for various components of radial cutter models.
Specifies the warranty duration and requirements for claims.
Lists conditions under which the warranty is void.
Disclaims implied warranties and limits representations.
Limits Keen Pump's liability for consequential or incidental damages.
States that Keen Pump is not responsible for labor costs.
Instructions for returning components for warranty service.
