Over-Speed alert
Command: speed1,+ Speed
Notes: The speed must be in km/h in 2 or 3 digitals. (01~255km/h)
Example: speed1,100
Suppose the over-speed alert that we want to set is 100km/h, when the device exceeds 100km/h, it will send the message “Over-speed! +GPS Info” to all registered phone
numbers.
To turn off this function, please send speed0 to the device.
Movement Alert
Command: M1, xxxM/KM
Notes: xxx must be 3 digitals. M means meters, KM means kilometers
The tracker must be stationary when setting this function
Example: m1,100m
When the tracker moves beyond 100 meters, it will send an SMS alarm to all registered phone numbers. To turn off
this function, please send M0 to the device.
(The settings must be at least 50 meters)
To Next Page
Loading...