EasyManua.ls Logo

Keeper Trakker KT2500 - User Manual

Keeper Trakker KT2500
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
ELECTRIC WINCH OWNER’S MANUAL
for
KT2500/KT2500C/KT3000/KT3000C
12 Volt DC
Designed for use on ATV, Utility Vehicle (UTV),
Vehicle Trailer and General Winching Applications.
Assembly & Operating
Instructions
PLEASE READ ALL SAFETY PRECAUTIONS AND WARNINGS
BEFORE INSTALLING AND USING THE WINCH! IF YOU HAVE ANY QUESTIONS
PLEASE CONTACT OUR CUSTOMER SERVICE DEPARTMENT LISTED BELOW.
KEEPER CORPORATION
6 INDUSTRIAL PARK DRIVE
NORTH WINDHAM, CT 06256
800-533-7372
sales@keepercorp.com
CAUTION

Questions and Answers

  • C
    Carla HenryAug 10, 2025
    What to do if my Keeper Winches motor will not operate?
    • H
      Heather CummingsAug 10, 2025
      If your Keeper Winches motor isn't working, several issues could be the cause. First, check for broken wires or a bad battery connection, ensuring all wiring is tight and clean. If the wiring is good, the switch may be inoperative; verify that the switch wires are correctly connected to the solenoid. Also, a blown circuit breaker could be the culprit, so try replacing it. In the event that all of these are fine, the winch or solenoid itself may be damaged, requiring replacement or repair.
  • R
    Raymond NelsonAug 15, 2025
    Why does my Keeper Trakker KT2500 Winches motor run with insufficient power?
    • L
      Laura WrightAug 15, 2025
      If your Keeper Winches motor runs, but lacks sufficient power or line speed, there are several potential reasons: * A weak or low battery: Recharge or replace the battery and check the charging system. * The battery to winch wire is too long: Use only the wires supplied with the winch. If you need a longer wire, decrease the wire size to 2 or 3 AWG. * Poor battery connection: Check the battery terminals for corrosion and clean them as necessary. * Poor ground: Inspect and clean the ground connections. * Damaged motor: Replace or repair the motor.
  • J
    Julia GarrettAug 20, 2025
    What to do if my Keeper Trakker KT2500 runs backwards?
    • B
      Barry AguilarAug 20, 2025
      If your Keeper Winches runs backwards, the issue likely lies in the wiring. Begin by rechecking the battery wires to ensure they are correctly connected. Next, verify the switch wires are properly wired. Finally, check the switch installation to ensure it is installed correctly.
  • L
    Lisa LoganAug 25, 2025
    Why does my Keeper Trakker KT2500 Winches motor runs extremely hot?
    • J
      jennifer02Aug 26, 2025
      If the motor of your Keeper Winches runs extremely hot, it might be due to a long period of operation; in this case, allow it to cool down. Alternatively, the motor may be damaged during operation, requiring replacement or repair.
  • C
    coxchaseAug 30, 2025
    What to do if Keeper Trakker KT2500 motor runs but drum does not turn?
    • R
      rmendozaAug 30, 2025
      If the motor of your Keeper Winches is running but the drum isn't turning, the clutch is likely not engaged. Engage the clutch to resolve this issue.
  • J
    John SilvaSep 4, 2025
    How to prevent Keeper Trakker KT2500 Winches from coasting?
    • J
      Jeffrey RobertsSep 4, 2025
      If your Keeper Winches coasts, it's likely due to an excessive load. To prevent this, reduce the load or use a double line.

Keeper Trakker KT2500 Specifications

General IconGeneral
Rated Line Pull2500 lbs
Remote ControlYes
Cable Length50 ft
MotorPermanent Magnet
Battery Requirements12V DC

Related product manuals