Table 2-2. Power Up Default Conditions
Function
Power
output
Default Condition
On
Standby (OPERATE LED off). Programmed to
o.ooo-6A.
Auto
Trig
Source
V-limit
l-limit
Set to inactive (AUTO LED is off).
Set to inactive (TRIG LED is off).
Active (SOURCE LED is on).
Set to 3V.
HI Limit set to 0.000.
LO Limit set to 0.000.
Time Set to 50msec (50.00-3).
Digit
Set to inactive.
INCR
Set to inactive (INCR LED is off).
DECR Set to inactive (DECR LED is off).
Cancel
Set to inactive.
Enter
Not affected by power up.
Exponent
Not affected by power up.
Talk
Talk function is disabled (TALK LED is off).
Listen
Listen function is disabled (LISTEN LED is off).
Remote
Remote function is disabled (REMOTE LED is off).
Display
The 4% digit display is set to
2-2
To Next Page
Loading...
Need help?
General
