8
chapter 3 "print parameter Settings" part),
this step is not in the show car number
and suggests the new car number input,
directly to step 6
Display the original cargo no. ask to user
enter new cargo number
Note:when the tare light is on,can go the step 4.do not need operate step1-3 each time.
2.One manual operation print weighing list
The goods
pounds, for
stability
Display the original car number. Ask user
input new vehicle number。
Enter vehicle number,such as 00123
Display the original cargo no. ask to user
enter new cargo number
FOR input【001】
Press【enter】
Note: when no this vehicle number tare, indicator will imprint the GW is current value,
tare is 0.
3.two weighing print weighing list (namely first after the first car or empty car heavy
weight after car, here to the former empty car for example)
The empty
vehicle is on
weighing, for
stability
Display the original vehicle number. ask
user input new number.
If the new number is the same with
before vehicle number, do not need to
enter new one.
Display the original cargo no. ask user
input new cargo no.
back to weighing state after 1.5 seconds
Heavy vehicle
is on
weihging, for
stability
Display the original car number. ask user
input the vehicle number the same as
"step 2"
Display the original car number. ask user
input the vehicle number the same as
"step 4"
Before use configuration for Auto print weigh list
The detail please check the《calibration manual》Chapter 6,section 6.,set Quto, Return to zero HL and
minimum print weigh L.
To Next Page
Loading...