7
Parameter setting does not meet requirements, please refer to
the related parameters input range
Zero negative weighing or instability cannot print, do not
meet back to zero conditions don't print; Storage of input
parameter not meets the requirement; Discrepancy zeros
conditions; Do not conform to the skin condition: unstable
negative; no tare information when check vehicle number
Print date of the storage of weighing less than has the record
date
N load cell’s communication wrong
N digital load cell’s communication and security is not
available
printer connection error, printer error or printer didn't have
paper, please add paper or press weighing key to exit
4.3.Other information tips：
enter trial deadline code
Appendix A: print operation for example:
In printing in the control parameters choose not to input car number, and money order, for in the operation
of the corresponding will print skip steps, use at the same time the current meter car number and money
order memory unit original data storage. If in the storage projects choose not to use car number or money
order, for in the print operation when also can skip the corresponding steps, and do not store and print the
corresponding project (as shown in the technical specifications chapter 6 and 6 Settings).
1. One manual operation preset tare print weighing list
Tip input tare weight values
Show the scale gross/net weight value, to
skin FuLiang logo.
Note: at this time to switch to display
meter net state (according to the
net/gross 】 can switch over the show
state).
Press【Save 1】
OR
Press【Save 2】
Display the original car number. Hint user
input new car number. Note: if user
storage projects choose not to use the car
number or in print control parameters
choose not to enter in the car number (see
To Next Page
Loading...