INTRODUCTION
Please read and follow any and all specific Warnings, Cautions and Notes that are
contained in this manual.
KEM Equipment, Inc. is pleased that you have selected a Kodiak engine for your
requirements. KEM Equipment, Inc. takes great pride in our tradition of quality products
produced from the GM Powertrain line of marine gasoline fuel engines.
KEM Equipment, Inc./ Kodiak Marine reserves the right to request any pertinent
maintenance information of your engine prior to authorization of warranties.
Overall safety and equipment reliability depend on continuous observation of sound
operating practices. Always observe required scheduled maintenance activities as
outlined. Never attempt to correct problems or repairs for which you are not qualified. At
the end of this manual, you will find a list of qualified Kodiak marine service dealers to
assist you in your area.
Always STOP the engine before refueling.
Always STOP the engine prior to any inspection / check or repair work.
Always maintain proper ventilation when working around gas or oil.
Always run the bilge blower for a minimum of 10 minutes prior to starting the
engine.
Do not stand close or hover over the engine prior to starting.
Ensure all safety guards are in place prior to starting the engine.
To help protect the starter and electrical components, make sure the bilge is free
of excessive water.
All KEM Equipment, Inc. engines are inspected and tested before leaving the factory.
However, certain checks should be made before placing the engine into regular service.
Please read the initial pre start-up inspection requirements in the Maintenance
section of this manual on page 37.
KEM Equipment Inc. reserves the right to discontinue models or accessories at any time
or to change specifications or designs without notice and without incurring obligation.
To Next Page
Loading...
Need help?
General
