2 / 56 – K410036900025-00 / 10.2020 – © www.kemper-olpe.de
Important of the document
Read this manual before commissioning, use or
maintenance, and follow the instructions given!
Always pass these instructions on to current the
device operating organisation and retain for later
reference!
Warnings
Be sure to read and follow the warnings in the
manual. Disregard of the warning information may
lead to injury or material damage!
Labelling of important warning information:
Danger! Electricity!
Indicates hazards that might result in
severe or fatal injury.
Warning! Indicates hazards that may
result in injury, material damage or
contamination of drinking water.
Note! Indicates hazards that may
result in damage to the system or
malfunctions.
Disposal
Local regulations on waste recycling and disposal
must be followed.
The product must not be disposed of
with household waste but must rather
be disposed of appropriately.
Old batteries must not be disposed
with household waste. Consumers are
obligated by law to take batteries to
a suitable trade or communal collection
site. Handing these batteries in is free
of charge. You can also send your used
batteries back to us.
Important notes for the device
operating organisation
Medium: Water
Max. ambient temperature 39°C,
Min. ambient temperature 2°C,
Max. temperature of the inflowing medium 35 °C,
Min. temperature of the inflowing medium 1 °C,
Minimum flow pressure DN 20 = 1 bar / 0.1 MPa,
Minimum flow pressure DN 25 = 1.5 bar / 0.15 MPa,
Max. flow pressure DN 20/25 4.0 bar / 0.4 MPa,
Pressure stage PN 10,
Outlet pump pressure
DN 20: 4.3 bar/0.43 MPa
DN 25: 5.9 bar/0.59 MPa
DU value:
DN 20: 0.83 l/s
DN 25: 1.67 l/s
EN
Table of contents Safety instructions
Safety instructions 2
Introduction | 0.1
Controller symbols
Program explanations 4
Operating modes | 2.0
2.1 Select operating mode 18
2.1.1 Time program 19
2.2.1 Automatic program 24
Cleaning | 3.0
3.1 Flush inlet pipe 28
3.2 Clean tank 39
Main menu | 1.0
1.1 System settings 6
1.1.1 • Language 7
• Date
• Time
• Activate accessories
• Error signal
• Battery change
• Factory settings
1.2 Pump 8
1.3 Error messages 12
1.4 Drain tank 13
1.5 Inlet control 17
Error messages | 8.0 52
Process | 4.0
4.1
Retrieve consumption data
40
USB menu | 5.0
5.1 Save system data 42
Updates | 6.0
6.1 Install updates 44
Battery change | 7.0 46
To Next Page
Loading...
