● Connect any pole of the charger to the engine’s terminal not linked to the
chassis (with same poles, meaning the anode should be connected with
anode), connect the other pole to the engine’s terminal which is linked to the chassis.
● Read the related instructions for the engine as provided by the
manufacturer carefully.
● Insert the power plug, turn the power switch to “ON” position, then
turn the function switch “charge/start” to “start” position. And the engine
can be started.
Attention: The start time for each time is 3 seconds; the start for the second time should be
120 seconds later. Five times of cycled start are available. If the engine is continuously
started, 10 minutes of interval must be ensured between two start cycles so that the
transformer inside the device can be cooled for restarting the engine.
To Next Page
Loading...
