- 15 -
3. Hydraulic Operation - With pump handle securely inserted into the pump
handle assembly, actuate the internal hydraulic cylinder by pumping the
pump handle back and forth. For Air-Over-Hydraulic operation, simply
connect your compressor to the lift and turn on the air. If the lift does not
rise, repeat step 2 above, by tightly closing the release valve. Do NOT
over-tighten the release valve.
4. As the lift is raised, the locking height/safety bar will lock into place. When
the lift is raised to the desired height stop actuating the lift and slowly open
the release valve by turning it to the left one quarter turn and allowing the
jack to retract (lower) the lift and drop onto the height lock.
NOTE: In order to lock the lift in its highest attainable height of 32”
you will have to manually position the height lock into the final
safety lock. Please use the supplied Safety Lock Bar Extender to
safely position the height lock into place.
5. If you inadvertently miss the desired height position, you can actuate the
lift using the lift pump handle and then following the lowering procedure
until you lock the lift in the desired height lock.
To Next Page
Loading...