Why Kendon Lifting Systems jack will not lift load?
If your Kendon Lifting Systems jack won't lift a load, it could be due to several reasons. First, make sure the release valve is tightly closed. Another potential cause is an overload condition, which needs to be remedied. It may also be due to a hydraulic unit malfunction, so ensure adequate air supply.
What to do if Kendon Lifting Systems jack will lift, but not maintain pressure?
If your Kendon Lifting Systems jack lifts but doesn't maintain pressure, check that the release valve is tightly closed and remedy any overload conditions. If these steps don't resolve the issue, the hydraulic unit may be malfunctioning.
Why Kendon Lifting Systems has poor lift performance?
Poor lift performance in your Kendon Lifting Systems could be due to a low fluid level, so ensure that the fluid level is correct. Another cause could be air trapped in the system. To resolve this, fully retract the ram, remove the oil filler plug to let any pressurized air escape, and then reinstall the oil filler plug.
What to do if Kendon Lifting Systems jack will not lower after unloading?
If your Kendon Lifting Systems jack won't lower after unloading, it might be because the reservoir is overfilled. In this case, drain the fluid to the proper level. Another possible reason is binding linkages; clean and lubricate the moving parts to address this.
Lists common risks and unsafe practices during operation.
Pre-operation checks and hydraulic system inspection procedures.
Steps and precautions for safely loading a motorcycle onto the lift.
General| Brand | Kendon |
|---|---|
| Model | Stand-Up |
| Category | Lifting Systems |
| Language | English |
To Next Page