- 19 -
2. Pull up and back on the motorcycle handlebars.
3. Keeping your hands on the handlebar brake, squeeze the motorcycle
brake lever as the wheel chock rotates backwards. This freezes the front
wheel of the motorcycle at the “balance point” between the closed
position and the open position as the wheel chock is rotating backwards.
4. Pull the motorcycle backwards again, releasing the motorcycle handlebar
brake lever. This will cause the wheel chock to rotate into the full open
position and the front wheel of the motorcycle to fall onto the main lift rail
assembly.
5. Now you can roll the motorcycle off of the lift.
Standing your Kendon Stand Up™ Lift for Storage
1. Fully lower the lift as described in the Lowering the Lift section.
2. Remove the ramp and store it separately. The ramp can also be
stored on the lift by placing the ramp between the front rail and rear
folding rail then securing with the rubber latch.
To Next Page
Loading...