42
FIRST STEPS
I. Attaching the watch strap
1. Remove all parts from the packaging and remove the protective film from
the watch face.
2. To attach a strap, insert the fixed pin on the sliding lock into the hole on
the watch strap.
3. Pull the knob on the sliding lock inward, and insert the pin into the
opening.
4. Release the button so that the clasp snaps into the watch and the strap
is secured.
5. To remove the strap, pull the quick release button inward and remove it.
II. Charging the watch
• IMPORTANT - before first use: Connect the charging cable to the
magnetic contacts and charge the watch for at least 3 hours. The
magnetic contacts of the charging cable will only fit onto the charging
contacts of the watch in one position, and will magnetically snap into
place.
• Info: With a full charge, the watch can run for up to 7 days, depending
on usage.
III. Putting on the watch and positioning it on the wrist
Place the watch on either wrist. The watch must be worn on the top of the
wrist, at least one finger‘s width away from the wrist bone.
The watch should fit tightly on the wrist so that the sensors are always in
contact with the skin. The watch should not be able to slip.
To Next Page
Loading...