iNSTALLATiON REQUIREMENTS
Tooms and Parts
Gather the required tools and parts before starting installation.
Tools needed for all installations:
Tools needed for gas installations:
Flat-blade screwdriver
#2 Phillips screwdriver
8" or 10" pipe wrench
8" or 10" adjustable wrench
(for gas connections)
1/4" nut driver or socket
wrench (recommended)
Tape measure
Level
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Tin snips (new vent
installations)
Vent clamps
Pliers
Caulking gun and compound
(for installing new exhaust vent)
Pipe-joint compound
resistant to LP gas
Parts supplied:
[
Leveling legs (4)
Parts package is located in dryer drum. Check that all parts
are included.
Parts needed:
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
Optional Equipment: (Not supplied with dryer)
Refer to your Use and Care Guide for information about
accessories available for your dryer.
Utility knife
To Next Page
Loading...
