SECTION 2. PREPARE YOUR MACHINE FOR SEWING
Prepare the Bobbin
• To Remove the Bobbin Casefrom the Machine • Wind the Bobbin
J
Remove the extension table from
the machine by pulling it to the
left. Open the shuttle cover by
pulling down the embossed part on
the left side of the cover.
Raise needle to its hi_ghest position
by rotating hand wheel toward you.
To remove bobbin case from shut-
tle, pul! open latch of bobbin case.
Pull bobbin case straight out of
shuttle.
J
clutch knob inside the hand wheel
toward you to stop the needle from
moving while you winding the
bobbin.
To Next Page
Loading...
