e
o
4
INSTALLING MACHINE
1, Loosen the two hinge screws under holes in the rear edge
of the machine bed.
2, Raise hinge pins in the cabinet or case.
S!ip machine head onto pins.
3. Tighten hinge screws securely. Lower machine head to
front flap. Screw spool pins in place. Place the plastic
spool holder onto the spool pin. Holder and pins are
packed in the accessory box.
CONNECTING MACHINE
Push the connector of the speed control onto three-prong
connector under the machine bedplate. See illustration 4.
Push the two prong plug of the speed control into any
110-120V. wall outlet,
To Next Page
Loading...
Need help?
General
