O
O
@
@
@
O
WINDING THE BOBBIN
1. Release clutch by turning clutch
knob toward you.
2. Draw thread from spool through
bobbin winder tension discs as
shown.
3. Pull end of thread through hole in
bobbin as shown.
4. Place bobbin onto bobbin winder
shaft with end of thread coming
from-the top of the bobbin.
Push bobbin winder latch against
bobbin until it clicks. Holding onto
end of thread, start machine.
When bobbin is slightly filled, snip
off end of thread.
5. Start machine. Wind thread until
bobbin winder latch releases.
6. Tighten clutch knob and remove
bobbin.
Two spool pins have been included
with this machine to aid in bobbin
winding, By placing a spool of thread
on the second spool pin, you may
wind your bobbin without unthreading
the machine.
9
To Next Page
Loading...
Need help?
General
