ZIPPER APPLICATION]
SETTINGS
Stitch Selector _"_
Stitch Length Control . . .12
Zipper Foot
Thumb /
screw
Zipper foot
adjusting
Needle entry
(right)
REGULAR ZIPPER
Pin or baste zipper to fabric and place the
work in position under the presser foot.
Loosen the zipper foot adjusting screw to
set the foot on the left side of the needle,
and sew the left side zipper as shown.
(Fig. 1) To sew the rightside zipper,
loosen the screw and bring the foot to
the right side Of the needle.
Fig. I
Fig. 2
Fig. 3
INVISIBLE ZIPPER
Adjust the foot so the needle is sewing
through the center hole of the foot
and one groove of the foot is riding on
the teeth of the zipper. See Fig. 2. Fol-
low the zipper manufacturer's instruc-
tionso
After zipper has been inserted, finish
sewing seam by shifting foot to side
position sewing through side notch.
CORDING
Foot can also be used to make cording
for slipcovers etc. Cover a cord with a
strip of bias fabric and sew as shown in
Fig. 3.
N OTE:
Use "Low Bar Sewing Machine ZIPPER
FOOT" (6757) for "invisible zipper" and
"cording", which can be obtained at any
stores of Sears Roebuck and Co.
28
To Next Page
Loading...
