Prepare the Bobbin
• To Removethe BobbinCasefrom the Machine
SECTION 2. PREPARE THE MACHINE FOR SEWING
• Wind the Bobbin
Remove the extension table from
the machine by pulling it to the
left. Open the shuttle cover by
pulling down the embossed part on
the left side of the cover.
Raise needle to its highest position
by rotating hand wheel toward you.
To remove bobbin case from shut-
tle, pull open latch of bobbin case.
Pull bobbin case straight out of
shuttle.
Release clutch by turning the
clutch knob inside the hand wheel
toward you to stop the needle from
moving while you wind the
bobbin.
9
To Next Page
Loading...
