Stardng To Sew
SECTION 2. PREPARE THE MACHINE FOR SEWING
Now that you are familiar with the controls on your machine and with the accessoriesprovided for the machine, you are ready to start to sew with your new
Kenmore sewing machine. Below are some good habits to follow each time you sit down to sew:
1.
2.
3.
Inspect the needle, it should be straight, properly set and sharp on the point. It should be the correct size for the fabric and thread being used. Do not be
afraid to change your needle frequently. Many of the new fabrics made of synthetic blends tend to dull the needles more easily than fabrics made of natural
fibers.
Before placing the material on the machine, see that the ends of the threads have been drawn about 4 inches to the rear of the machine. Hold on to threads
during the sewing of the first 3 or 4 stitches of the seam.
Test the machine stitch on a scrap of the fabric you plan to use. The fabric should be double thickness. Adjust the machine for the length of stitch and
tension suitable to the fabric.
4. Fabric should be placed under the presser foot with the bulk of the material to the left of the needle and the right edge of the material placed on the 5/8"
seammarking on the needle plate when making a simple seam.
5. Run the machine at a slow even speed. The more pressureyou put on the foot control, the faster the machine will sew.
6. Fasten each seam by back tacking sewing a few stitches in reverse.
7. Always finish sewing each seam with the needle at its highest point.
8. Guide the fabric gently with your hand in front of the needle. Never pull or hold the fabric in such a way that the normal feeding isaltered.
9. When turning the hand wheel manually, always turn it toward you.
17
To Next Page
Loading...
