Need help?Do you have a question about the Kenmore 385.16221300 and is the answer not in the manual?
General| Type | Mechanical |
|---|---|
| Model | 385.16221300 |
| Brand | Kenmore |
| Foot Control | Yes |
| Built-in Stitches | 22 |
| Needle Threader | No |
| Free Arm | Yes |
| Bobbin Type | Drop-in |
| Stitch Options | Decorative |
| Buttonhole Styles | 1 |
Lists causes and fixes for skipped stitches in sewing machine operation.
Lists causes and fixes for fabric not feeding correctly during sewing.
Lists causes and fixes for the upper thread breaking during sewing.
Lists causes and fixes for the bobbin thread breaking during sewing.
Lists causes and fixes for the sewing needle breaking.
Lists causes and fixes for unusual noise during sewing machine operation.
Lists causes and fixes for distorted stitch patterns.
Lists causes and fixes for incorrect buttonhole stitching.
Instructions for removing the machine's front face cover.
Instructions for removing the machine's top cover.
Instructions for removing the machine's base plate.
Instructions for removing the machine's bed cover.
Instructions for removing the machine's belt cover.
Instructions for removing the machine's free arm cover.
Instructions for removing the machine's front cover.
Instructions for removing the machine's rear panel.
Procedures for checking and adjusting the top thread tension.
Procedures for checking and adjusting presser bar height and alignment.
Procedure for adjusting the needle's sideways movement during zigzag stitching.
Checks for proper needle position during straight stitching.
Procedure to adjust needle position for straight stitching.
Procedure to check the equal distribution of needle swing.
Procedure to adjust the needle bar supporter for balanced needle swing.
Procedure to check the balance of stretch stitches.
Procedure to adjust stretch stitch balance for forward and reverse stitches.
Procedure to check the feed dog height using a gauge.
Procedure to adjust the feed dog height.
Preparation and check for needle bar height.
Procedure to adjust the needle bar height.
Preparation and check for needle to shuttle timing.
Procedure to adjust the needle to shuttle timing.
Procedure to check needle clearance to the shuttle hook.
Procedure to check and adjust backlash in the lower shaft gear.
Procedure to check the stitch balance for buttonholes.
Procedure to adjust buttonhole stitch balance.
Procedure to check the needle position in relation to stitch width.
Procedure to adjust the needle position for zigzag and straight stitches.
Procedure to check the zero feeding setting for the feed dogs.
Procedure to adjust the zero feeding setting.
Procedure to adjust basic needle position for zigzag and straight sewing.
Procedure to adjust the length of buttonholes made with the automatic foot.
Procedure to adjust bar tack timing for buttonholes.
Procedures for replacing and adjusting the needle threader plate.
Procedure to check and adjust the motor belt tension.
To Next Page
