12. DINNER PLATE
a) Press Dinner Plate repeatedly until the number you wish appears in the
display, "9.0", "12.0", "18.0" oz will display in order.
b) Press START ADD 30 SEC to cook, oven beeps once. Oven beeps 5 times when
cooking is finished.
13, PIZZA
a) Press Pizza repeatedly until the number you wish appears in the
display, "4.0", "8.0", "14.0" oz will display in order.
b) Press STARTADD 30 SECto cook, oven beeps once. Oven beeps 5 times when
cooking is finished.
14. MEMORY FUNCTION
(1) Press 0 Memory to program and choose up to three cooking procedures.
Each procedure wilt be indicated by 1,2 or 3 in the display.
(2) Press 0 Memory until your desired procedure number appears in the display.
Press START ADD 30 SEC to begin it. A maximum of two cooking stages can be set
for each procedure.
(3) To program a procedure, follow the steps listed below. Example: Cook food at 80%
Power Level for 3 minutes and 20 seconds; save as memory 2.
a. Press 0 Memory twice; screen displays 2.
b. Press Time Cook once, then press "3","2" and "0" in order.
c. Press Power Level once, then press "8" for "PL8" to dTsptay.
d. Press STARTADD 30 SECto save the procedure. Oven beeps once. Procedure is saved
as memory 2. Press STARTADD 30 SECagain to immediately start procedure if desired.
e. To choose the procedure from the memory list, press 0 Memory twice. Screen will
disptay "2"; press STARTADD 30 SECto run procedure.
Note: The procedure will remain programmed until the oven is unplugged or there is a
power failure. If either occurs, the procedure will have to be reprogrammed into
the oven.
EN-12
To Next Page
Loading...
