To Next PageTo Next PageWhat to do if Kenmore 415.162180 clicks but doesn't light?
If you hear noise from the spark module but no sparks appear at any electrodes when pushing the ignition button on your Kenmore Gas grill, the output lead connections may not be complete. Remove and reconnect all output connections at the module and electrodes to ensure they are secure and tight.
Why are the sparks weak on my Kenmore Gas grill?
If the sparks are not at all electrodes or not at full strength on your Kenmore Gas grill, several factors could be at play. Start by checking and reconnecting all output connections at the module and electrodes. If possible, check for arcing between output wires and the grill frame in a dark location while operating the ignition system. A weak battery can also cause this issue, so replace it with a new AAA-size alkaline battery. Ensure the electrodes are dry; if wet, use a paper towel to remove any moisture. Lastly, inspect the electrodes for cracks or breaks, and replace them if necessary.
Read manual before cooking; failure can cause fire or explosion.
Product by-products contain chemicals known to cause cancer or birth defects.
Explains danger, warning, and caution symbols and their meanings.
Conforms to local codes, uses correct LP gas, and ensures electrical grounding.
Sears will repair or replace any grill part defective in material or workmanship for one year.
Sears will replace specific grill parts defective in material or workmanship after one year.
Contact Sears for service; warranty void if used for commercial or rental purposes.
List of all parts for Model No. 415.162180 with key, quantity, description, and part number.
Diagram illustrating the location of all parts for Model No. 415.162180.
Position base and attach legs with carriage bolts and wing nuts. Do not fully tighten.
Snap front panels together, attach wires and condiment wire.
Assemble grill bottom, control panel, sideburner body, frame, tube, valve, and grate.
Attach lid, gauge, bezel, night light, swingaways, and cooking grate.
Connect tank wire, secure LP tank, hang grease clip, install battery and ignitor button.
Requirements, removal, transport, storage, and safety for LP tanks.
Properties of LP gas and procedures for safe tank filling.
Steps to connect regulator and perform leak tests on the gas system.
Guidelines for safe grill operation, clearance, apartment use, and fire prevention.
Instructions for lighting burners, cleaning components, and handling spider obstructions.
Grill storage, direct/indirect cooking, and essential food safety guidelines.
Times and temperatures for cooking various foods like beef, pork, poultry, seafood, and vegetables.
Addresses no ignition, low flame, flame blow-out, flare-ups, and grease fires.
Diagnoses electronic ignition problems and LP tank filling issues.
General| Fuel type | Liquid Propane |
|---|---|
| Ignition type | Electronic |
| Grates material | Porcelain-coated cast iron |
| Wheels | Yes |
| Side burner | Yes |
