TROUBLESHOOTIHG,(ONT.
ice maker is not
producing ice
ANDWATER,com.
Ice makerarm is not incorrectposition
Householdwatersupplyis not reaching
water vaIve
Copper or plastictubing has kinks
Water pressure is too low
Check freezertemperature
icebin is not installed properly
improperwatervalvewas installed
Confirm ice maker arm isdown See Freezer Features .........
sect!0nin your owner's manual for details
Check water connectionprocedure written in Installing Your
Refrigerator.
Turnoff water suppiy and remove kinks ttkinks cannot be
rem°ved._..[ep!acetubing
Water pressuremustbe between 20 to100 poundsper square
inchto functionproperly A minimumpressureof 35pounds per
square inchis recommendedfor refrigeratorswithwater filters
Seetemperature controls section in Installing Your
Refrigeratorto adjust your controls. Freezer must be
between0 to2+F (-18 to -17 ° C) !oproduceice.
See ice bin section for proper installation and alignment.
Checkwater connection procedure in yourInstallation
Instructions Self*piercingand _'m"saddle valvescauselow
water pressureand may clog the line over time The
manufacturer is nat responsiblefor property damage due
Waterfiller needs to be replaced
Filterindicatorsensor needsto be reset.
Plastictubingwas usedto complete water
connection
......................... to improper installation or water connection,
Waterfilter indicator light If fiiter isnot available,replace withbypass filter See
is red DispenserFeaturessection for directions.
See Dispenser Features section for directions.
Refrigeratoris leaking The manufacturerrecommendsusing copper tubingfor
water installation.Plastic is less durable and can cause leakage
The manufacturer is not responsible for property damage
.....due.to .!mproper installation or water connection. .......................
improper watervalve was +nstafled Check water connectionprocedurein yourInstallation
Instructions Self-piercing and _,_"saddle valvescause low
water pressureand may dog the lineover time The
manufacturer is not responsiblefor property damage due
to improper installationor water connection.
Waterpressureis low. Water pressuremust be between 20 to 100 pounds per
Allow approximately12 hoursfor water in holdingtank to chili
Discard firstglass of waier and refill
ice forms in inlet tube
to ice maker
Water flow is slower
than normal
Freezertemperatureistoo high,
Water pressureis too low
improperwatervalve wasinstalled
Copperor plastictubinghaskinks.
Waterfitter is cloggedor needs to be
changed:
Befrigera!or hasbeenrecent!Yinsta!led, _
Water supplyin holding tank has been
depleted.
Water has settledinto water lines outside
holdingtankand has warmed to room
temperature. .........
Dispenserwater is not
cold
square inchto functionproperly A minimumpressure of35
poundsper square inch isrecommendedfor refrigeratorswith
water filters.
See temperaturecontrolssection in installing Your
Refrigeratorto adjust your controls. Freezermust be
between 0 to 2° F (-18 to -17". C) to produceice+
Water pressuremust be between20 to 100 pounds per
square inchto function properly.A minimum pressureof 35
poundsper squareinchis recommendedfor refrigeratorswith
water filters.
Check water connectionprocedureinyour installation
Instructions. Self-piercing and _A_"saddle valves causelow
water pressureand may clog the line overtime The
manufactureris not responsiblefor property damagedue
.....to!mproper..!nsta!!ation or water connection...
Turnoff watersupply and remove kinks ifkinks cannot be
removed,re lace tubin.
Changewater filter
To Next Page