Optional Features
_ CAUTION
To avoid personal injury or property damage, handle
tempered glass shelves carefully. Shelves may break
suddenly if nicked, scratched, or exposed to sudden
temperature change.
Shelf Adjustment
Refrigerator shelves are easily adjusted to suit individual
needs. Before adjusting the shelves, remove all food.
To adjust sliding shelves:
1. Remove shelf by pulling forward to stop position.
2. Lift front edge up and puii out.
To replace shelf, rest side edges on any pair of shelf rails
and carefully push shelf back into position.
Sliding Glass Shelf Sliding Wire Shelf
Door storage
Door bins, shelves, and racks are provided for convenient
storage of jars, bottles, and cans. Frequently used items
can be quickly selected.
Some models have door racks or bins that can
accommodate gallon-sized plastic drink containers and
economy-sized jars and containers. Some racks are
adjustable for maximum storage capacity.
The dairy compartment_ which is warmer than the general
food storage section, is intended for short term storage of
cheese, spreads, or butter.
Door Rack
NOTE
Cantilever shelves are supported at the back of the
refrigerator. Cantilever shelves are available in either
glass or wire.
To adjust cantilever shelves:
1. Lift front edge up.
2. Puii shelf out.
Replace the shelf by inserting the hooks at rear of the shelf
into the waft bracket. Lower the shelf into the desired slots
and lock into position.
SpiliProof TM glass shelves (some models) catch and hold
accidental spills. In some models, the SpiliProof TM shelves
slide out for easy access to food and for fast cleaning. The
shelves slide out independently of the cantilever brackets.
Just puii the front of the shelf forward. The shelf can be
extended as far as the stopper wiii allow, but it is not
removable from the cantilever bracket.
Full-width Cantilever
Glass Shelf
Adjustable door bins
Cantilever Glass Shelf
Fixed and SEding
Some models have adjustable door bins that can be
moved to suit individual needs.
To move door bins:
1. Lift bin straight up.
2. Remove bin.
3. Place bin in
desired position.
4. Lower bin
onto supports
until locked in place.
14
To Next Page
Loading...
