Care & Cleaning
Never Clean Condenser (some models)
If your refrigerator is equipped with a Never Clean
condenser, there's no need to clean the condenser
under normal operating conditions. If the refrigerator is
operated under particularly dusty or greasy conditions,
or if there is significant pet traffic in your home, it may
be necessary to periodically clean the condenser for
maximum efficiency.
Replacing the freezer light bulb (some models)
1. Unplug refrigerator.
2. Wear gloves as protection against possible broken glass.
3. Unsnap iicjht cover as shown.
4. Unscrew and replace old bulb with an appliance
bulb of the same wattage.
5. Replace light shield.
6. Remember to plug the refrigerator back in.
Replacing mid-level refrigerator light bulb
(some models)
1. Unplug refrigerator.
2. Wear gloves as protection against possible broken glass.
3. Unsnap iicjht cover.
4. Unscrew and replace old bulb(s) with an appliance
bulb of the same wattage.
5. Replace light cover.
6. Remember to plug the refrigerator back in.
_ CAUTION
Wear gloves to avoid cuts when replacing light bulbs.
_J
FreezerLightCoverRemoval
Refrigerator Mid-Level Light Cover Removal
Short Vacations
Long Vacations
Moving
Vacation and Moving Tips
° Leave refrigerator operating during vacations of 3 weeks or less.
° Use all perishable items from refrigerator compartment.
° Turn automatic Icemaker off and empty ice buckeh even if you will only be gone for a few days.
° Remove all food and ice if you will be gone one month or more.
° Turn off automatic Icemaker and turn water supply valve to closed position.
° Turning refrigerator controls to "OFF" by pressing and holding the On/Off button for 3 seconds
(electronic) or turning control knobs to "0" (manual) on the mechanical controls only controls your
refrigerator's coolincj system. To turn off power to your refrigerator you must unplug the power cord
from the wall outlet.
° Clean interior thoroughly.
° Leave both doors open to prevent odors and mold build-up. Block doors open if necessary.
° Remove all food and ice.
° If using handcart, load from side.
° Adjust rollers all the way up to protect them during sliding or moving.
° Pad cabinet exterior to avoid scratching surface.
20
To Next Page
Loading...
