iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER.
iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.
READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasollne or other flammable vapors and liquids
in the vicinity of fhls or any other appliance.
_f the informationin thismanual isnot followed exactly, a _re
or explosion may result causing property damage, petsona_ injury or death.
FOR YOUR SAFETY:
m Do not store or use gasoline or other flammable vapors and liquids
in the vicinity of fhls or any other appliance.
WHAT TO DO iF YOU SMELL GAS:
* Do nat fry to light any appliance.
* Do nat touch any elec|rlcal switch; do not use any phone in your
building.
" Immedlately call your gas supplier from a neighbor's phone. Fellow
the gas suppller's instructions.
* If you cannot reach your gas supplier, call the fire department.
Insfallaflan and service must be performed by a quallfled installer,
service agency or the gas supplier.
Note: For appliance installed in the
State of Massachusetts see page 2.
Front
view
49"
Maximum
A_
36t 1/8"
/
,\
30" minimum clearance between the top of the cooking
surface and the bottom of an unprotected wood or
metal cabinet; or 24" minimum when bottom of wood
or metal cabinet is protected by not less than 1/_" flame
retardant millboard covered with not less than no. 28
MSG sheet steel, 0.015" stainless steel, 0.024" aluminum
or 0.020" copper. The minimum clearance is 0" for the
rear of the range. Follow all dimension requirements
provided above to prevent property damage, potential
fire hazard, and incorrect countertop and cabinet cuts.
Clearances and Dimensions
1. Locatlon_Check Iocatlon where the range will be
installed. Check for proper electrical and gas supply, and
the stability of floor.
Printed in United States
Avoid Iocatlng cabinet storage space above the surface
burners to eliminate the possibility of cabinets catching
on fire, or personal burns from reaching for the cabinets
over the heated units. Avoid Iocaflng cabinet storage
space above the surface burners. The absence of cabinets
will eliminate the chance of cabinets catching on rite, and
eliminate the possibility of receiving personal burns from
reaching for the cabinets over flaming surface burners.
if cabinet storage is to be provided, risk can be reduced
by insfalllng a range hood that projects horizontally a
minimum of 5" beyond the bottom of the cabinets.
2. Dimensions that are shown must be used. Given
dimensions provide minimum clearance. Contact
surface must be solid and level.
318201790 (0912) Rev. A
To Next Page
Need help?
General
