Kenmore 795.7205 Series

Questions and Answers

K
Kevin MayAug 15, 2025
Why is my Kenmore 795.7205 Refrigerator icemaker not making enough ice?
- C
  Crystal Chen DDSAug 16, 2025
  If your Kenmore Refrigerator's icemaker isn't making enough ice, it could be due to several reasons. The demand might exceed the icemaker's capacity, which is about 100 cubes in 24 hours. Check if the house water supply is properly connected and the valve is fully open and not clogged. Consider replacing the water filter approximately every six months, when the indicator turns on, if the water dispenser output decreases, or when the ice cubes are smaller than normal. Low water pressure or a reverse osmosis system could also be the cause; in the case of low pressure, you may need to contact a plumber. Finally, inspect the tubing connecting the refrigerator to the house supply valve for any kinks and straighten them out.
N
nancygloverAug 21, 2025
What to do if my Kenmore 795.7205 is not dispensing ice?
- M
  Michael MurilloAug 21, 2025
  If your Kenmore Refrigerator is not dispensing ice, ensure that all refrigerator doors are completely closed. Check the ice bin for ice cubes that are clumped or stuck together, and break them up. If the delivery chute is clogged with frost or ice fragments, remove the ice bin and clear the chute with a plastic utensil. Make sure the dispenser display is not locked by pressing and holding the Lock button for three seconds. Also, confirm that the ice bin is not empty and that the shutoff arm/sensor is not obstructed; it may take up to 90 minutes for additional ice to be available once the bin has been exhausted.
A
Andrea TranAug 25, 2025
Why is my Kenmore 795.7205 icemaker not making ice?
- J
  Jenna WebsterAug 25, 2025
  If your Kenmore Refrigerator icemaker isn't making ice, several factors could be the cause. If the refrigerator was recently installed or the icemaker was just connected, allow up to 24 hours for it to start making ice. Ensure the icemaker is turned on by locating the on/off switch and setting it to the ON (I) position. Check that the ice detecting sensor is not obstructed and is kept clean. Verify that the refrigerator is connected to a water supply and the supply shutoff valve is fully open. Also, make sure the icemaker shutoff arm or sensor is not obstructed, ensuring free movement or a clear path between the two sensors.
A
Ashley LeAug 27, 2025
Why is food freezing in my Kenmore 795.7205 Refrigerator compartment?
- K
  karismithAug 27, 2025
  If food is freezing in your Kenmore Refrigerator compartment, it might be due to a few reasons. Food with high water content placed near an air vent can cause freezing, so rearrange those items. Also, incorrect temperature control settings can cause this issue; adjust the control one increment at a time and wait for the temperature to stabilize. Lastly, if the refrigerator is installed in a cold location (below 55°F or 13°C), it can cause food to freeze. Refer to the Setting the Controls section for more information.
K
Kimberly SmithSep 2, 2025
Why is my Kenmore 795.7205 Refrigerator or Freezer section too cold?
- K
  kayla08Sep 2, 2025
  If your Kenmore Refrigerator or Freezer section is too cold, it is likely due to incorrect temperature control settings. Adjust the control one increment at a time and wait for the temperature to stabilize. Refer to the Setting the Controls section for more information.
O
opetersSep 5, 2025
Why does my Kenmore 795.7205 Refrigerator water have a bad taste or odor?
- D
  Deanna JohnsonSep 5, 2025
  If your Kenmore Refrigerator water has a bad taste or odor, it could be due to minerals like sulfur in the water supply, which may require a water filter. A water filter may need to be installed to eliminate taste and odor problems. Also, the water filter may need replacing approximately every 6 months, when the water filter indicator turns on, when the water dispenser output decreases, or when the ice cubes are smaller than normal. If the refrigerator was recently installed, dispense 2.5 gallons of water (flush for approximately 5 minutes) to remove trapped air and contaminates from the system.
M
mosleyrobertSep 8, 2025
Why is there interior moisture buildup in my Kenmore Refrigerator?
- J
  Julia FuentesSep 9, 2025
  If you notice interior moisture buildup in your Kenmore Refrigerator, try these steps: reduce the frequency and duration of door openings. Also, check that the doors are closing correctly. Maintaining a reasonable level of humidity in your home can help. If a defrost cycle recently completed, wait 30 minutes to confirm that the proper temperature has been restored. Ensure food is correctly packaged by wiping containers dry and storing food in sealed packaging. See the Doors will not close correctly section in the Troubleshooting section.
J
jlewisSep 12, 2025
Why does frost or ice crystals form on frozen food in my Kenmore Refrigerator?
- C
  Cody WongSep 12, 2025
  If you're seeing frost or ice crystals on frozen food outside of the package in your Kenmore Refrigerator, it could be because the door is opened frequently or for long periods. Try to reduce how often and how long you open the door. Also, check to make sure the door is closing properly. Refer to the Doors will not close correctly or pop open section in the Troubleshooting section.
R
Ronnie WallNov 17, 2025
Why is my Kenmore 795.7205 Refrigerator and Freezer not cooling?
- C
  Cody AdkinsNov 17, 2025
  If your Kenmore Refrigerator and Freezer are not cooling, there are several possible reasons. First, check if the refrigerator control is set to OFF and turn it ON. Refer to the Setting the Controls section for proper temperature settings. Ensure the refrigerator is not in Demo Mode, which disables cooling; refer to the Setting the Controls section for instructions on how to disable it. If the refrigerator was recently installed, relocated, plugged in, or power was restored, it can take up to 24 hours to reach the desired temperature. Also, make sure the doors are closed completely, and the refrigerator is not installed in a hot location (above 110°F). Finally, if the refrigerator is in the defrost cycle, wait 30 minutes after completion to see if the proper temperature has been restored. ...
T
Tyler JenkinsDec 1, 2025
Why is my Kenmore 795.7205 Refrigerator or Freezer section too warm?
- K
  Kerry WalshDec 1, 2025
  If your Kenmore Refrigerator or Freezer section is too warm, it might be due to a few reasons. If the refrigerator was recently installed, allow up to 24 hours to reach the desired temperature. Make sure air vents are not blocked, and rearrange items to allow proper airflow. Reduce how often and how long the doors are opened. Ensure the unit isn't in a hot location (above 110F). Allow hot food to cool before placing it in the refrigerator. Check that the doors are closing correctly. If the temperature control isn't set correctly, adjust it one increment at a time and wait for the temperature to stabilize. Also, wait 30 minutes after a defrost cycle to confirm the proper temperature has been restored. See the Doors will not close correctly or pop open section in Parts & Features Troubleshoo...