Bracket
Valve Inlet
Water Valve
Copper water line
from household
water supply
(Include enough tubing in loop to allow
moving refrigerator out for cleaning.)
IMPORTANT
After connecting the water supply, refer
to “How to Prime the Water Supply
System” for important information
about priming an empty water supply
system.
Your refrigerator’s water supply system
includes several tubing lines, a water
lter, and a water valve.
Connecting the Water Supply
If you use braided exible stainless
steel tubing - The nut is already
assembled on the tubing. Slide nut
onto valve inlet and nger tighten nut
onto valve. Tighten another half turn
with a wrench; DO NOT over tighten.
See Figure 2.
5. With steel clamp and screw, secure
water supply line (copper tubing only)
to rear panel of refrigerator as shown.
6. Coil excess water supply line (copper
tubing only), about 2½ turns, behind
refrigerator as shown and arrange
coils so they do not vibrate or wear
against any other surface.
7. Turn ON water supply at shuto
valve and tighten any connections
that leak.
8. Reconnect refrigerator to electrical
power source.
To Next Page
Loading...
Need help?
General
