Problem Possible Cause Solution
Machine Power cord not plugged in. Plug in power cord.
Stops No power at plug. Check electrical source or call
electrician.
Fuse blown or circuit Replace fuse or reset circuit breaker.
breaker open. if problem continues, call electrician.
Using an extension cord. Do not use extension cords.
Timer is not Iined up. Turn timer to the right slightly
and pull to start.
Timer knob not puIledout. Set and pull out knob.
Machine is overloaded. Wash smalIer loads.
Agitator Not The top of the agitator moves This is normal.
Working only in one direction.
The top of the agitator isIoose. This is normal.
Water Level The top of the agitator ismuch This is normal.
Too Low/Not higher than the highest water
Completely Ievel.This creates a perception
Filling of the washer not being full.
Tub is Tub pulled forward when Ensure tub is centered before
Crooked unloading, starting washer.
Tub moves. This is normal.
Unit not level. Ensure front feet are installed and
nuts are tightened. LeveIwasher.
Reset rear legs (see "lnstaIlation
Instructions," Section G).
Lint on Load Improper sorting. Sort lint givers from lint takers
and by color.
Ovedoading. Lint can be trapped in load if
ovedoaded, Wash smaller Ioads.
Paper or tissue in pockets. Clean out pockets before washing.
Not enough detergent. Use enough detergent to
hold lint in water.
Detergent not dissolving. Use wash water warmer than
Water temperatures Iower 70°F (21°C).
than 70°F (21°C).
36
To Next Page
Loading...
