- 24 -
PowerMate
®
will
not run when
attached.
PowerMate
®
connections
unplugged.
Plug in firmly.
W orn or broken belt.
See
BELT CHANGING AND BRUSHROLL
CLEANING
(page 20-21).
Dirty brushroll or end caps.
See
BELT CHANGING AND BRUSHROLL
CLEANING
(page 20-21).
Tripped overload protector in
PowerMate
®
. See
OVERLOAD
PROTECTOR
(page 15).
Remove any items that may be caught or
jammed, then restart. If vacuum cleaner starts
and stops again, clean brushroll and end
caps, then restart.
Handle switch set to FLO O R
position.
Slide handle switch to CARPET position to
activate PowerMate
®
.
Check bag
indicator
activates.
Full or clogged dust bag. Change bag.
Dirty filters. Clean/ change filters.
Blocked airflow passage. Clear blockage from airflow passage.
Certain attachment tools.
This is normal. The indicator will turn to green
when tool is removed.
Vacuum cleaner
picks up
moveable rugs
or PowerMate
®
pushes too hard.
W rong pile height setting. Adjust setting.
Suction too strong.
Slide the electronic suction control to a lower
power setting.
Cord will not
rewind.
Dirty power cord. Clean the power cord.
Cord jammed. Pull out cord and rewind.
Vacuum cleaner
leaves marks on
carpet.
W rong vacuuming pattern. See
VACUUMING TIPS
(page 12).
TROUBLESHOOTING
To Next Page
Loading...
