- 10 -
3. Lower the wand from upright position by
pressing on the HANDLE RELEASE pedal.
5. Push the power switch on the canister
body to turn the vacuum suction ON or OFF.
To turn on the PowerMate
®
motor, slide
the handle switch to the CARPET position.
The PowerMate
®
agitator will start to spin.
To use the canister motor only, slide the
handle switch to the FLOOR position. The
PowerMate
®
agitator will stop spinning.
Agitator On Agitator OFF
To rewind: Turn off and unplug the vacuum
cleaner. Hold the plug while rewinding to
prevent damage or injury from the moving
cord. Push cord rewind button.
1. Pull cord out of canister to desired length.
The cord will not rewind until the cord rewind
button is pushed.
2. Plug the polarized power cord into a 120
Volt outlet located near the floor.
4. Select a pile height setting by pressing
the height adjustment pedal on the rear of
the PowerMate
®
. The pile height setting
shows on the indicator.
Handle
Release
Height
Adjustment Indicator
Height
Adjustment
Pedal
To Next Page
Loading...
Need help?
General
