Before you call for service, review this list. It may save you time and expense. The list includes common
occurrences that are not the result of defective workmanship or materials in this appliance,
Range is not level. Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust
leveling legs at base of range until the rack is level. When range is level, cooktop may
appear out of alignment if countertop is not level.
Weak, unstable floor. Be sure floor is level and can adequately support range. If floor is
sagging or slopping, contact a carpenter to correct the situation.
Kitchen cabinet misalignment may make range appear to be unlevel. Be sure cabinets are
square and have sufficient room for range clearance.
Cannot move Cabinets not square or are built in too tight: Contact a cabinet maker to correct the Problem:.............
appliance easily, Contact builder or installer to make appliance accessible.
Appliance must .........................................................................................................
be accessible for Carpet interferes with range. Provide sufficient space so range can be lifted over carpet.
service,
Entire range or oven sure cord/plug is plugged tightly into outlet: .....................................................................................................................................................................................
does not operate, Service wiring is not complete. Call an authorized servicer.
.........Eiectiical power outage: Check house iights to be sure: Cali your iocai eiectiic company for .......
.................. service. ....................................................
Oven control beeps Electronic control has detected a fault condition. Press CANCEL to clear the display and
and displays any F stop beeping. Reprogram oven. If fault recurs, record fault number. Press CANCEL and call
code error (ex,: FIO) an authorized servicer for assistance.
Oven light does not Replace or tighten bulb. See Changing Oven Light section in this Use & Care Guide.
work. Electrical power outage. Check house lights to be sure. Call your local electric companyfor service.
Surface unit does No power to the appliance. Check steps under "Entire Range or Oven Does Not Operate" in
not heat, this Before you Call checklist.
Incorrect control setting. Make sure the correct control is on for the surface unit to be used.
Surface units too Incorrect control setting. Make sure the correct control is on for the surface unit to be used.
hot or not hot Lightweight or warped pans used. Use only fiat, evenly balanced, medium or heavyweight
enough, cookware. Flat pans heat better than warped pans. Cookware materials and weight of the
material affect heating. Heavy-and medium- weight pans heat evenly. Because lightweight
pans heat unevenly, foods may burn easily.
Hetalmarks. Sliding or scraping of metal utensils on cooktop surface. Do not slide metal utensils on
cooktop surface. Use a ceramic-glass cooktop cleaning cream to remove the marks.
"Cooktop Cleaning - Ceramic Glass Cooktop Models" section under General Cleaning.
Scratches or Coarse particles such as salt or sand between cooktop and utensils can cause scratches. Be
abrasions on sure cooktop surface and bottoms of utensils are clean before usage. Small scratches do not
cooktop surface, affect cooking and will become less visible with time.
Cleaning materials not recommended for ceramic-glass cooktop have been used. See
ii
"Cooktop Cleaning - Ceramic Glass Cooktop Models" section under General Cleaning.
Cookware with rough bottom has been used. Use smooth, flat-bottomed cookware.
Brown streaks or Boilovers are cooked onto surface. Use razor blade scraper to remove soil. "Cooktop
,i
specks. Cleaning - Ceramic Glass Cooktop Models section under General Cleaning.
To Next Page
Loading...
Need help?
General