18
Temperature Guide
In wash water temperatures colder than 60°F (15.6°C),
detergents do not dissolve well. Soils may be difficult to remove.
Auto Temp Control
ATC (Auto Temp Control) electronically senses and maintains a
uniform water temperature. ATC regulates incoming hot and cold
water. The ATC is automatically turned ON when a cycle is
selected. See Preset Cycle Settings table in “Cycles.”
■ ATC works for the wash temperature with Warm/Warm,
Warm/Cold, and Cold/Cold settings.
■ ATC works for the rinse temperature with the Warm/Warm
setting.
■ The Cold rinse temperatures depend on the cold water at
your faucet.
Laundry Guide
Refer to this chart for suggested load types and their corresponding cycles. Listed to the right are the options available to each of these
washer cycles.
Wash Water Temperature Suggested Fabrics
HOT Whites and pastels
Heavy soils
WARM Bright colors
Moderate to light soils
COLD Colors that bleed or fade
Light soils
CYCLE SUGGESTED LOAD TYPE AVAILABLE OPTIONS
Delay Start Prewash 2nd Rinse Cycle Signal
Whitest Whites Soiled white fabrics ✔✔✔ ✔
Heavy Duty Heavily soiled underwear, towels, shirts, etc., made
of cotton
✔✔✔ ✔
Normal/Casual Normally soiled blouses, shirts, overalls, etc., made
of polyester, nylon, cotton, linen, or cotton blends
✔✔✔ ✔
Express Wash Small loads of 2-3 lightly soiled cotton, polyester,
nylon, and cotton blends.
✔✔✔
Delicate Curtains and delicate clothing, dresses, skirts, shirts
and blouses
✔✔✔
Rinse/Drain & Spin All loads ✔✔✔
Clean Washer No clothes ✔✔
To Next Page
Loading...
