21
The opener does not
run. Power LED flash
rapidly (the LED is ON
200ms per second,
normally the LED ON
500ms per second).
1. Battery is over-discharged. Check the voltage of the battery. The voltage
of the battery should above 22V to make the gate opener work normally.
The opener does not
run. Power LED does
not ON.
1. Make sure the connection between the battery and control board is correct
and fastening.
2. Check the fuse in the control board. Replace the fuse if it was burnt out.
3. Check the control board. Replace the control board if necessary.
Gate moves a little
and then reverse or
stop
1. The selected force is too small to move the gate. Turn the Potentiometer
clock-wise to increase the force.
2. Disconnect the gate from the gate operator and check that the gate slides
freely without any binding.
Gate opener does not
run when you press
the remote control
1. Make sure the remote has been programmed to the control board before
using.
2. The battery of the remote may be exhausted. Replace the battery and try
it again.
3. Check the control board. Replace the control board if necessary.
Gate can open but
does not close
1. Make sure the connection of the photocell beam is not blocked if the
photocell is used.
2. Check if the close limit switch is broken.
3. Check the control board. Replace the control board if necessary.
Gate automatically
opens, but does not
automatically close
1. Setting of DIP switch #1 would be wrong. Please set the dip switch
correctly according to the push/pull to opener installation of the gate opener.
To Next Page
Loading...
Need help?
General
